TM 9-2320-302-34
0103 00-2
REAR SUSPENSION CONTROL ROD AND V-ROD REPLACEMENT - CONTINUED
0103 00
REMOVAL - CONTINUED
3.
Remove two nuts (4), six screws (5), spacers (6), and two V-rods (7) from vehicle.
INSTALLATION
NOTE
To install V-rods, perform steps 1 through 3 and 5.
To install control rods, performs steps 4 and 5.
When installing V-rods, ensure labels on rods are facing upward. Forward V-rods are marked FDA.
Rear V-rods are marked RDA.
1.
Position two V-rods (7) to vehicle and loosely install spacers (6), six screws (5), and two nuts (4).
2.
Tighten four screws (5) at frame bracket to 136 lb-ft (184 Nm).
3.
Tighten nut (4) at each axle bracket to 427 lb-ft (579 Nm).
4.
Install two control rods (3) to vehicle with four screws (2) and nuts (1). Tighten nuts to 136 lb-ft (184 Nm).
5.
Remove trestles and floor jack.
END OF WORK PACKAGE
4
5
5
5
6
5
4
7
7
3
3
2
1