TM 9-2320-363-34-2
A I R C O N D I T I O N E R E V A P O R A T O R C O I L R E P L A C E M E N T ( C O N T )
4.
5.
6.
7.
NOTE
Any time air conditioning system refrigerant is evacuated, replace receiver-drier
REPLACE RECEIVER-DRIER (page 11.1-14).
EVACUATE AND CHARGE THE SYSTEM
WITH REFRIGERANT (page 11.1-2).
LEAK TEST THE SYSTEM (TM 9-2320-
363-20). BE
S U R E T O
ADD
REFRIGERANT
OIL
TO
THE
COMPRESSOR TO REPLACE THAT
WHICH WAS LOST WHEN THE SYSTEM
WAS DISCHARGED (page 11.1-23).
WIPE THE EXPANSION VALVE (5) AND
REFRIGERANT LINE CONNECTIONS
CLEAN, AND WRAP THEM WITH
INSULATING TAPE.
INSTALL THE HEATER CORE COVER
(4), AND TIGHTEN FOUR SCREWS (3)
SECURELY.
8.
INSTALL THE DASH SKIRT PANELS.
a.
POSITION THE ELECTRICAL ACCESS PANEL SUPPORT BRACKET ON THE CAB
TUNNEL, THEN INSTALL THE SIX FASTENERS.
b.
POSITION THE TWO PANELS ON THE RIGHT SIDE OF THE ELECTRICAL ACCESS
PANEL, THEN INSTALL THE FIVE FASTENERS THAT ATTACH THE PANELS.
c.
POSITION THE PANEL ON THE LEFT SIDE OF THE ELECTRICAL ACCESS PANEL, THEN
INSTALL THE THREE FASTENERS THAT ATTACH THE PANEL.
9.
d.
POSITION THE ELECTRICAL ACCESS PANEL, THEN INSTALL THREE SCREWS.
INSTALL THESE ADDITIONAL DASH PANELS.
a.
CONNECT THE FLEX HOSES TO THE DUCTS AT THE BACK OF THE GLOVE
BOX ASSEMBLY. MAKE SURE THAT THE HOSES ARE NOT TWISTED.
CONNECT THE BLUE AIR LINE TO THE AIR CYLINDER AT THE BACK OF THE
GLOVE BOX. INSTALL THE GLOVE BOX ON THE DASH. TIGHTEN THE
FASTENERS UNTIL SNUG. INSTALL THE TOP COVER ON THE GLOVE BOX
ASSEMBLY.
b.
INSTALL THE DASH SKIRT PANEL ON THE RIGHT SIDE OF THE CAB (BELOW
THE GLOVE BOX).
c.
INSTALL THE TWO BOTTOM SCREWS THAT ATTACH THE HEATER AND AIR
CONDITIONER CONTROL PANEL TO THE DASH.
25-50
Change 1
