TM 9-2320-363-34-2
NOTE
Perform steps 1 and 2 only if fixed resistor has been replaced.
1.
INSTALL FUEL TUBE (1) IN FIXED RESISTOR (2).
2.
INSTALL FLANGE (3), NUT (4), AND NEW COMPRESSION SLEEVE (5) ON FUEL TUBE (1).
3.
CONNECT WIRE (6) AND INSTALL NEW SEMS SCREW (7) AND NEW KEP NUT (8) ON FIXED
RESISTOR (2).
4.
INSTALL FIXED RESISTOR ASSEMBLY (9) AND TWO NUTS (10) ON HEATER (11).
5.
INSTALL TAPPING PLATE (12) AND TWO SCREWS (13). DO NOT TIGHTEN SCREWS.
6.
INSTALL COVER (14) ON HEATER (11) AND TIGHTEN FOUR NUTS (15).
7.
INSTALL FUEL CONTROL VALVE BRACKET (16) AND TIGHTEN TWO SCREWS (13).
NOTE
Follow-on Maintenance:
Install fuel control valve (page 25-14).
25-25