1.
2.
3.
4.
5.
6.
7.
8.
TM 9-2320-363-34-2
LOOSEN TWO SCREWS (1) AND REMOVE FUEL CONTROL VALVE BRACKET (2) FROM HEATER
(3).
LOOSEN FOUR NUTS (4) AND REMOVE COVER (5) FROM HEATER (3).
REMOVE TWO SCREWS (1) AND TAPPING PLATE (6).
REMOVE TWO NUTS (7) AND FIXED RESISTOR ASSEMBLY (8) FROM HEATER (3).
REMOVE KEP NUT (9) AND SEMS SCREW (10) AND DISCONNECT WIRE (11) FROM FIXED
RESISTOR (12). DISCARD KEP NUT AND SEMS SCREW.
NOTE
Perform steps 6 thru 8 only if fixed resistor fails multimeter check in inspection.
GRIND OR CUT COMPRESSION SLEEVE (13) OFF FUEL TUBE (14). DISCARD COMPRESSION
SLEEVE.
REMOVE NUT (15) AND FLANGE (16) FROM FUEL TUBE (14).
REMOVE FUEL TUBE (14) FROM FIXED RESISTOR (12).
Use general cleaning methods to clean all parts (page 2-30).
25-23
