TM 9-2320-363-34-2
5.
6.
7.
8.
REMOVE TWO SCREWS (14) AND TWO LOCK WASHERS (15) FROM DRUM (11). DISCARD LOCK
WASHERS.
C A U T I O N
Drum must be placed in press with splined end down. Failure to do so will
cause damage to components.
USING SUITABLE PRESS, REMOVE SHAFT (16) AND TWO KEYS (17) FROM DRUM (11) AS
SHOWN.
REMOVE RETAINING RING (18), THRUST PLATE (19), BEARING (20), AND SEAL (21) FROM
MOTOR END SUPPORT (9). DISCARD SEAL.
REPEAT STEP 7 FOR GEAR END SUPPORT.
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
Use general repair methods to repair damaged parts (page 2-33).
23-5
