35.
36.
37.
38.
39.
40.
TM 9-2320-363-34-2
STAKE NEW RETAINER (42) INTO TWO SLOTS IN SECTOR SHAFT (40).
MAKE SURE ADJUSTING SCREW (41) CAN STILL BE TURNED BY HAND AND END PLAY IS
STILL 0-0.002 IN. (0-0.05 mm). IF NOT, REPEAT REMOVAL STEP 12 AND INSTALLATION STEPS
32 THRU 35.
APPLY LIGHT COATING OF OIL TO BUSHING INSIDE COVER (43)
SEAL (44) ON INSTALLATION END OF TRUNNION INSTALLER (3)
SHOULDER OF TOOL.
INSTALL SEAL (44) INSIDE COVER (43).
AND NEW SEAL (44). INSTALL
WITH SPRING SIDE TOWARD
APPLY LIGHT COATING OF OIL TO BEARING SURFACE OF SECTOR SHAFT (40). INSTALL
SECTOR SHAFT (40) IN SIDE COVER (43) BY THREADING ADJUSTING SCREW (41)
COUNTERCLOCKWISE UNTIL SOLID, THEN BACK OFF 1/2 TURN SO SIDE COVER (43) ROTATES
FREELY.
INSTALL VENT PLUG (45) AND NUT (46) HAND-TIGHT.
19-27
