TM 9-2320-363-34-2
51.
52.
53.
54.
55.
56.
W A R N I N G
Do not rotate input shaft more than 1-1/2 turns from center position. Doing so
will incorrectly set poppets, causing steering problems resulting in possible
injury to personnel.
LOOSEN NUT (46).
USING LB-IN. TORQUE WRENCH ON INPUT SHAFT (16), TIGHTEN ADJUSTING SCREW (41) SO
THAT INPUT SHAFT (16) REQUIRES TORQUE OF 45-50 LB-IN. (5.1-5.6 N.m) TO TURN 180
DEGREES FROM CENTER IN BOTH DIRECTIONS.
BACK OFF ADJUSTING SCREW (41) 1/2 TURN AND NOTE TORQUE REQUIRED TO TURN INPUT
SHAFT (16) 180 DEGREES FROM CENTER IN BOTH DIRECTIONS.
TIGHTEN ADJUSTING SCREW (41) SO THAT TORQUE REQUIRED TO TURN INPUT SHAFT (16)
180 DEGREES FROM CENTER IN BOTH DIRECTIONS INCREASES 6-8 LB-IN. (0.68-0.90 N.m)
FROM READING NOTED IN STEP 53.
HOLD ADJUSTING SCREW (41) FIRMLY AGAINST HOUSING (2) AND TIGHTEN NUT (46) TO 40-45
LB-FT (54-61 N.m).
CHECK TORQUE READING ON INPUT SHAFT (16). IF READING EXCEEDS 40 LB-IN. (4.5 N.m),
REPEAT STEPS 51 THRU 56.
NOTE
Follow-on Maintenance:
Install steering gear (page 7-4).
19-31/(19-32 Blank)
