TM 9-2320-363-34-2
NOTE
To aid in installation, coat all interior components with light coat of clean engine
oil prior to installation.
1.
INSTALL NEW SEAL (1) WITH LIP FACING BUSHING UNTIL SEAL (1) IS SEATED AGAINST INSIDE
LIP OF BODY (2).
2.
INSTALL NEW SEAL (3) WITH LIP FACING OUTWARD UNTIL SEAL (3) IS SEATED AGAINST SEAL
(1).
3. INSTALL NEW DRIVE PIN (4), NEW CARRIER (5), AND TWO SNAP RINGS (6) ON SHAFT (7).
4.
INSTALL TWO NEW O-RINGS (8) AND TWO NEW SEALS (9) IN END PLATE (10).
5.
INSTALL END PLATE (10) IN BODY (2) WITH TWO SEALS (9) FACING UP.
C A U T I O N
Failure to install locating pin as shown will cause pump to operate in reverse,
which could result in equipment damage.
6.
INSTALL NEW LOCATING PIN (11) IN LOWER LEFT HOLE OF END PLATE (10).
NOTE
If seals can be seen, port plate
7.
INSTALL NEW PORT PLATE (12) AND NEW CAM (13)
TOWARD LOCATING PIN (11).
8.
INSTALL SHAFT (7) AND 10 NEW ROLLERS (14).
must be reversed.
WITH ARROW ON CAM (13) POINTING UP
19-5