TM 9-2320-363-34-2
REAR-REAR AXLE DIFFERENTIAL CARRIER REPAIR (CONT)
19.
20.
21.
22.
23.
24.
25.
NOTE
If installing new ring gear and drive pinion, perform steps 19 thru 24.
Replace ring gear and drive pinion as matched set. Gear set match number is
on gear head of drive pinion and front face or outer diameter of ring gear.
Pinion cone variation number is used to adjust depth of pinion in differential
carrier. Pinion cone variation number is on end of gear head of drive pinion or
outer diameter of ring gear.
RECORD NEW PINION CONE VARIATION NUMBER.
RECORD OLD PINION CONE VARIATION NUMBER.
IF OLD PINION CONE VARIATION NUMBER IS +, SUBTRACT NUMBER FROM SHIM PACK
THICKNESS IN DISASSEMBLY, STEP 21.
IF OLD PINION CONE VARIATION NUMBER IS -, ADD NUMBER TO SHIM PACK THICKNESS IN
DISASSEMBLY, STEP 21.
IF NEW PINION CONE VARIATION NUMBER IS +, ADD NUMBER TO SHIM PACK THICKNESS
DETERMINED IN STEP 21 OR 22.
IF NEW PINION CONE VARIATION NUMBER IS -, SUBTRACT NUMBER FROM SHIM PACK
THICKNESS DETERMINED IN STEP 21 OR 22.
NOTE
If installing same ring gear and drive pinion,
Disassembly, step 21.
If installing new shim pack, use at least three
middle of pack.
ALINE OIL SLOTS ON SHIM PACK (14) WITH OIL SLOTS
INSTALL SHIM PACK (14).
use shim pack removed in
shims with thickest shim in
ON DIFFERENTIAL CARRIER (8) AND
17-62
