TM 9-2320-363-34-2
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR (CONT)
68.
69.
70.
71.
72.
73.
74.
REMOVE INNER BEARING CUP (5) AND SHIM PACK (4).
TO CORRECT HIGH CONTACT PATTERN, ADD SHIM(S) TO SHIM PACK (4).
TO CORRECT LOW CONTACT PATTERN, REMOVE SHIM(S) FROM SHIM PACK (4).
PERFORM STEPS 8 THRU 66 TO DETERMINE CONTACT PATTERN.
IF CONTACT PATTERN IS TOO FAR TOWARD HEEL OF GEAR TEETH, REPEAT STEP 62 TO
DECREASE BACKLASH TO MOVE PATERN TOWARD TOE OF GEAR TEETH.
IF CONTACT PATTERN IS TOO FAR TOWARD TOE OF GEAR TEETH, REPEAT STEP 61 TO
INCREASE BACKLASH TO MOVE PATTERN TOWARD HEEL OF GEAR TEETH.
INSTALL PIN (26) IN BEARING CAPS (19 AND 20) SO PIN (26) IS BETWEEN LUGS OF
ADJUSTING RING (25).
17-34