TM 9-2320-363-34-2
53. TIGHTEN
STEP 52.
TWO ADJUSTING RINGS (25) ONE NOTCH FROM ZERO END PLAY MEASURED IN
BEARING PRELOAD IS NOW SET.
54. ADJUST DIAL INDICATOR TO ZERO.
55. ROTATE RING GEAR (13) WHILE READING DIAL INDICATOR. RUNOUT MUST NOT EXCEED 0.008
IN. (0.200 mm).
56. IF RUNOUT IS EXCEEDED, PERFORM DISASSEMBLY STEPS 37 AND 38.
57. INSPECT ALL RING GEAR SUBASSEMBLY (22) PARTS AND DIFFERENTIAL CARRIER (3) FOR
POSSIBLE EXCESSIVE RUNOUT CAUSES. REPLACE DEFECTIVE PART(S).
58. REPEAT STEPS 45 THRU 55.
17-31
