TM 9-2320 -363-34-2 CRANKSHAFT REPLACEMENT This  task  covers: a. Removal b. Cleaning c. lnspection d. Repair e. Installation Tools  and  Special  Equipment: General  Safety  Instructions: Shop  Equipment,  SC  4910-95-CL-A31 Tool Kit, SC 5180-90-CL-N05 Crankshaft  Gear  Remover/installer,  J35642 Hydraulic Ram and Pump, J35951-175 Materials/Parts: Lubriplate  105 International Compound No. 2 Solvent,  Drycleaning Plastigauge Rope, l/2-In.  Nylon Oil,  Lubricating Personnel  Required:  (2) References: TM  9-2320-363-20 Equipment   Condition: Reference Page  3-148 Page  3-199 Page 12-141 Page  12-93 TM  9-2320-363-20 TM  9-2320-363-20 Page 3-231 Appendix B, Item 35 Appendix B, Item 29 Appendix B, Item 54 Appendix B, Item 46 Appendix B, Item 49 Appendix B, Item 37 Condition   Description Flywheel  Housing Removed 0il  Pump  Removed Piston and Cylinder Assembly  Removed Bull/Idler  Gear  Assembly Removed Timing  Reference  Sensor (TRS) Removed Synchronous  Reference Sensor  (SRS)  Removed Crankshaft  Oversize  Front Oil Seal Removed W A R N I N G Crankshaft   weighs   408   l b (185.23   kg).   Use   suitable lifting   device   to   lift   and support  crankshaft.  Failure  to do  so  could  result  in  serious injury  to  personnel. . TO prevent  injury,  compressed air will not exceed 30 psi (207 kPa).  Use  only  with  effective chip   guarding   and   personal protective equipment, goggles, shield, and gloves. Adhesives,   solvents,   and sealing  compounds  can  burn easily,   can   give   off   harmful vapors,   and   are   harmful   to skin   and   clothing.   To  avoid injury   or   death,   keep   away from  open   fire   and   use   in well-ventilated area. If adhesive,   solvent,   or   sealing compound   gets   on   skin   or clothing,   wash   immediately with  soap  and  water. 12-41