TM 9-2320-363-34-2
W A R N I N G
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or
death, keep away from open fire and use in well-ventilated area. If adhesive,
solvent, or sealing compound gets on skin or clothing, wash immediately with
soap and water.
22.
23.
24.
25.
26.
27.
APPLY SEALING COMPOUND TO FLANGE OF BEARING CAGE (10) AND DIFFERENTIAL CARRIER
(22).
NOTE
If gear set is reused, install same shims as removed. If new gear set is used,
install 0.023-in. (0.6-mm) shim pack.
INSTALL SHIMS (23) ON DIFFERENTIAL CARRIER (22).
ALINE MATCHMARKS AND INSTALL BEARING CAGE (10) ON DIFFERENTIAL CARRIER (22).
APPLY THREAD LOCKING COMPOUND AND INSTALL EIGHT SCREWS (24) AND EIGHT
WASHERS (25) ON DIFFERENTIAL CARRIER (22). TIGHTEN SCREWS TO 160-176 LB-FT (217-239
N.m).
APPLY COAT OF SEALING COMPOUND AROUND OUTSIDE EDGE OF SHIMS (23).
INSTALL NEW OIL SEAL (26), YOKE (27), WASHER (28), AND NEW LOCK NUT (29) ON PINION
(17). USING YOKE HOLDER BAR, TIGHTEN NUT TO 450-600 LB-FT (610-814 N.m).
16-15
