TM 9-2320-363-34-2
6.
7.
8.
9.
10.
INSTALL BEARING CAP (2) ON SPLINE END OF OUTPUT SHAFT (5) UNTIL INNER BEARING
CONE (4) IS FIRMLY SEATED IN BEARING CUP (3).
INSTALL OUTER BEARING CONE (7) ON SPLINE END OF OUTPUT SHAFT (5).
COAT OUTER BEARING CONE (7) WITH GAA.
PRESS OUTER BEARING CONE (7) UNTIL SEATED IN OUTER BEARING CUP (3).
W A R N I N G
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or
death, keep away from open fire and use in well-ventilated area. If adhesive,
solvent, or sealing compound gets on skin or clothing, wash immediately with
soap and water.
COAT THREADS OF PLUG (8) WITH PIPE SEALING COMPOUND AND INSTALL PLUG (8).
NOTE
Follow-on Maintenance:
Install lower front output shaft in transfer case (page 15-2).
15-40