TM 9-2320-363-34-2
NOTE
Coat outside sealing edges of cup plugs with non-hardening sealant.
Coat pipe plugs with pipe sealant.
3.
USING PLUG INSTALLER, INSTALL 11 CUP PLUGS (4) ON TOP, FRONT, AND REAR SIDES OF
CYLINDER HEAD TO 0.098-0.118 IN. (2.5-3.0 mm) BELOW MACHINED SURFACE.
4.
USING PLUG INSTALLER, INSTALL TWO CUP PLUGS (5) ON FRONT AND REAR SIDES OF
CYLINDER HEAD.
5.
INSTALL TWO SQUARE DRIVE PIPE PLUGS (6) ON FRONT SIDE OF CYLINDER HEAD,
FLUSH-TO-BELOW SURFACE.
6.
INSTALL
7.
INSTALL
8.
INSTALL
9.
INSTALL
10. INSTALL
CONNECTOR (7) ON LEFT REAR SIDE OF CYLINDER HEAD.
ELBOW (8) ON LEFT FRONT SIDE OF CYLINDER HEAD.
TWO PIPE PLUGS (9) ON RIGHT SIDE OF CYLINDER HEAD.
PIPE PLUG (10) ON RIGHT SIDE OF CYLINDER HEAD.
FUSE PLUG (11) ON RIGHT SIDE OF CYLINDER HEAD.
12-25
