TM 9-2320-363-34-2
Section VI. FORWARD CLUTCH AND HOUSING REPLACEMENT AND
REPAIR
This section illustrates and describes procedures for removal, disassembly, cleaning, inspection, repair,
assembly, and installation of the forward clutch and housing.
Replacement and repair of the forward clutch and housing is general support maintenance.
FORWARD CLUTCH AND HOUSING REPLACEMENT AND REPAIR
This task covers:
a. Removal b. Disassembly c. Cleaning d. Inspection e. Repair f. Assembly
g. Installation
INITIAL SETUP
Tools and Special Equipment:
General Safety Instructions:
Shop Equipment, SC 4910-95-CL-A31
Tool Kit, SC 5180-90-CL-N05
Clutch Spring Compressor, J24204
Collector Ring Installer and Staker, J24200
Inner Seal Protector, J24216-01
PTO Gear Removal Fixture, J26899
Fourth Clutch Alining Tool, J24221
Materials/Parts:
Ring, Seal (2)
P/N 23019652
Ring, Seal
P/N 6833980
Ring, Seal
P/N 6836799
Shim Stock
Appendix B, Item 53
Oil, Lubricating
Appendix B, Item 37
Solvent,
Appendix B, Item 54
Drycleaning
Compound,
Appendix B, Item 14
Retaining
Personnel Required: (2)
Equipment Condition:
Reference
Condition Description
W A R N I N G
A d h e s i v e s , s o l v e n t s , a n d
sealing compounds can burn
easily, can give off harmful
vapors, and are harmful to
skin and clothing. To avoid
injury or death, keep away
f r o m o p e n f i r e a n d u s e in
w e l l - v e n t i l a t e d
a r e a .
If
adhesive, solvent, or sealing
c o m p o u n d g e t s o n s k i n or
c l o t h i n g , w a s h i m m e d i a t e ly
with soap and water.
To prevent injury, compressed
air will not exceed 30 psi (207
kPa), Use only with effective
chip guarding and personal
protective equipment, goggles,
shield, and gloves.
H o t P T O g e a r c a n c a u se
b u r n s . W e a r h e a t - r e s i s t a n t
gloves.
Page 14-35
Torque Converter
Housing and Front
Support Removed
14-54