TM 9-2320-363-34-2
32.
33.
34.
35.
36.
37.
36.
39.
INSTALL SIX CAPSCREW BOLTS (32). TIGHTEN BOLTS TO 175-225 LB-IN. (20-25 N.m).
SUPPORT CYLINDER HEAD (33) ON BENCH, DECK SIDE UP, AND INSTALL NEW COPPER
GASKET (34) IN BORE (35).
INSTALL INLET VALVE SEAT (36) IN BORE (35) WITH RAISED SIDE OF VALVE SEAT (36)
TOWARD DECK OF CYLINDER HEAD (33).
NOTE
Make sure inlet valve is centered on inlet valve seat.
INSTALL INLET VALVE (37) ON TOP OF INLET VALVE SEAT (36).
NOTE
Make sure inlet valve spring is centered on inlet valve.
INSTALL INLET VALVE SPRING (38) ON TOP OF INLET VALVE (37).
THREAD INLET VALVE STOP (39) CAREFULLY INTO CYLINDER HEAD (33) UNTIL INLET VALVE
SPRING (38) IS SEATED ON INLET VALVE STOP (39).
USING INSERT REMOVER/INSTALLER TOOL (40), TIGHTEN INLET VALVE STOP (39) TO 70-90
LB-FT (95-122 N.m).
REPEAT STEPS 33 THRU 38 FOR OTHER INLET VALVE STOP (39).
12-135
