TM 9-2320-363-34-1
M C S C H A S S I S W I R I N G H A R N E S S R E P L A C E M E N T
This task covers:
a. Removal b. Cleaning
c. Inspection d. Installation
Applicable Configuration:
M917A1 w/MCS
Tools and Special Equipment:
Shop Equipment, SC 4910-95-CL-A31
Tool Kit, SC 5180-90-CL-N05
References:
TM 9-2320-363-20
Equipment Condition:
Reference
Condition Description
TM 9-2320-363-20
Batteries Disconnected
NOTE
l
Wiring harness and leads are secured in place by wire ties, cushion clamps, and screw terminals
l
Only remove hardware securing harness or lead to be removed.
DISCONNECT AND REMOVE MATERIAL CONTROL SYSTEM (MCS) CHASSIS WIRING HARNESS
USING ILLUSTRATION AND TABLE AS A GUIDE.
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
NOTE
l Wiring harness and leads are secured in place by wire ties, cushion clamps, and screw
terminals.
l
Make sure harness is secure and all hardware is tight.
INSTALL AND CONNECT MATERIAL CONTROL SYSTEM (MCS) CHASSIS WIRING HARNESS USING
ILLUSTRATION AND TABLE AS A GUIDE.
N O T E
Follow-on Maintenance:
Connect batteries (TM 9-2320-363-20).
4-47.2
Change 1
