TM 9-2320-363-34-1
(3) WIPE ANY OIL FROM CAMSHAFT BEARING SHELLS AND CAMSHAFT JOURNALS.
(4) PLACE PIECE OF PLASTIGAUGE (8) FULL WIDTH OF EACH UPPER CAMSHAFT BEAR-
ING SHELL (6) ABOUT 1/4 IN. (6-7 mm) OFF CENTER.
(5) INSTALL CAMSHAFT BEARING CAPS (7) AND CAMSHAFT BEARING SHELLS ON COR-
RECT CAMSHAFT JOURNALS AND INSTALL SEVEN CAMSHAFT CAP BOLTS (9).
TIGHTEN BOLTS TO 75-86 LB-FT (101-116 N.m).
(6) INSTALL TWO ROCKER SHAFT STUDS (10) IN CAMSHAFT BEARING CAPS (7) NO. 1
AND NO. 7. TIGHTEN STUDS TO 75-86 LB-FT (101-116 N.m).
(7) INSTALL TWO ROCKER SHAFTS (11) ON SEVEN CAMSHAFT BEARING CAPS (7).
(8) INSTALL EIGHT ROCKER SHAFT SADDLE WASHERS (12), SIX BOLTS (13), AND TWO
NUTS (14). TIGHTEN BOLTS AND NUTS TO 75-86 LB-FT (101-116 N.m).
(9) REMOVE TWO ROCKER SHAFT NUTS (14), SIX BOLTS (13), EIGHT SADDLE WASHERS
(12), AND TWO ROCKER SHAFTS (11).
(10) REMOVE TWO ROCKER SHAFT STUDS (10).
(11) REMOVE SEVEN OUTBOARD CAMSHAFT CAP BOLTS (9), SEVEN CAMSHAFT CAPS (7),
AND SEVEN BEARING SHELLS (6).
3-171
