TM 9-2320-363-34-1
CAMSHAFT AND BEARINGS REPLACEMENT (CONT)
NOTE
Performing step 10 will move camshaft drive gear hub and thrust plate forward
approximately 1/4 in. (6-7 mm) until thrust plate seal is clear of camshaft front
bearing cap and cylinder head.
10. INSTALL CAMSHAFT GEAR PILOT (13) ON CAMSHAFT DRIVE GEAR ACCESS OPENING (14) AND
INSTALL THREE BOLTS (15). THREAD PILOT PULLER SCREW (16) INTO END OF CAMSHAFT
DRIVE GEAR HUB UNTIL PULLER SCREW (16) BOTTOMS OUT.
11.
IF THERE IS DOUBT OF CAMSHAFT ACCEPTABILITY, DETERMINE EXTENT
WEAR AS FOLLOWS:
A. USING SET OF 0.0015-0.010 IN. (0.038-0.254 MM) FEELER GAGES
SQUARE, HARD MATERIAL (18). MEASURE FLATS ON INJECTOR
CAMSHAFT LOBES (20).
OF CAMSHAFT LOBE
(17) AND PIECE OF
RISE SIDE (19) OF
3-166
