TM 9-2320-363-34-1
2.
RIGHT SIDE ONLY: REMOVE LOCK NUT (6), CLAMP (7), SCREW (8), WASHER (9), AND CLAMP
(10) FROM BRACKET (11). DISCARD LOCK NUT.
3.
RIGHT SIDE ONLY: REMOVE TWO NUTS (12), TWO WASHERS (13), TWO SCREWS (14),
BRACKET (11), AND WASHER (15) FROM REAR ENGINE MOUNT (5).
4.
5.
6.
W A R N I N G
Engine weighs 2,850 lb (1294 kg). Use hoist with lifting capacity of 5,000 lb
(2270 kg) to lift and support engine. Failure to do so could result in injury to
personnel.
C A U T I ON
Lift engine only enough to take weight off engine mounts. If engine is lifted
too far, wiring harnesses may be crushed by cab crossmember.
USING SUITABLE LIFTING DEVICE, LIFT ENGINE (16) SLIGHTLY.
NOTE
Steps 5, 6, and 8 are for left side.
REMOVE TWO SCREWS (17), TWO WASHERS (18), TWO SCREWS (19), AND REAR ENGINE LEG
(20) FROM FLYWHEEL HOUSING (21).
REMOVE TWO WASHERS (22) AND TWO ISOLATORS (23) FROM REAR ENGINE MOUNT (5).
W A R N I N G
Cab weighs 1,100 lb (499 kg). Use suitable jack stands to support cab.
Failure to do so could result in serious injury to personnel.
7.
USING SUITABLE JACK STANDS, SUPPORT CAB AT CAB MOUNTS (24) AS CLOSE TO FRAME
RAIL (25) AS POSSIBLE.
8.
REMOVE SIX NUTS (26), SIX WASHERS (27), SIX SCREWS (28), SIX WASHERS (29), AND REAR
ENGINE MOUNT (5) FROM FRAME RAIL (25).
9.
REPEAT STEPS 5, 6, AND 8 FOR RIGHT SIDE.
3-53
