TM 9-2320-363-10
3-9.
WHEEL AND TIRE ASSEMBLY REPLACEMENT (ALL
EXCEPT M917A1 AND M917A1 W/MCS (Con’t).
NOTE
If replacing inner rear tire, loosen both outer and
inner wheel nuts.
Wheel nuts on left side of vehicle are left hand
threads (turn right to loosen, turn left to tighten).
Wheel nuts on right side of vehicle are right hand
threads (turn left to loosen, turn right to tighten).
(3)
Remove wheel nuts on wheel to be removed.
(4)
Place jack in position (step a).
Hydraulic jack is intended only for lifting truck, not for
supporting vehicle to perform maintenance. Do not get
under truck after it is raised unless it is properly sup-
ported with blocks or jackstands. Failure to observe this
warning may result in death or injury to personnel.
(5)
Raise jack until tire(s) clears ground.
Use caution when lifting or handling wheel and tire
assembly. It is heavy and could cause injury if improp-
erly lifted or if it falls on you.
(6)
For front or outer rear tire, remove wheel nuts and wheel and
tire assembly.
(7)
If replacing inner rear tire, remove wheel nuts and wheel and
tire assembly.
6).
c.
Install Wheel and Tire Assembly.
(1)
Manually inflate spare tire to proper pressure (paragraph 3-
3-25
