TM 9-2320-363-10
Table 3-1. Troubleshooting (Con’t).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2.
Check system for leaks.
If leaks are found, notify Unit Maintenance.
Step 3.
Check if radiator cooling fins are free of mud, snow, ice, or
debris.
Remove anything that blocks or impedes cooling fins.
Step 4.
Check cooling fan drive belts for looseness.
If belts are loose, notify Unit Maintenance.
Step 5.
Check engine oil level.
If engine oil is low, fill to correct level (Appendix F).
Step 6.
Check transmission fluid level.
If transmission fluid level is low, fill to correct level
(Appendix F).
11.
ENGINE CRANKS BUT FAILS TO START.
Fuel tank cap may become hot during vehicle operation.
Use hand protection when removing fuel cap.
Step 1.
Check fuel gage with ignition switch in ON position.
If empty, add fuel (paragraph 3-6).
Step 2.
Check air cleaner restriction indicator.
If indicator is not clear, notify Unit Maintenance.
Step 3.
If operating M915A2 or M916A1 in temperature below 32°F
(0°C), check that cold weather starting procedure was used.
Perform cold weather starting procedure (paragraph 2-14).
3-10
