TM 9-2320-363-10
2-28.
OPERATE WINCH (M916A1 AND M916A2) (Con’t).
(6)
Direct crew member to disconnect wire rope from payload.
(7)
Have crew member pull on wire rope and keep fairly taut and
start rewinding drum by pushing down on winch line control lever (4).
(8)
Ensure that wire rope winds neatly onto drum without tan-
gling, kinking, twisting, or overlapping. Ensure that coils on drum are tight and close
together.
(9)
Direct crew member to signal when enough slack has been
taken up to anchor the eye.
(10)
Have a crew member anchor wire rope eye (1) to anchor (2).
(11)
Shut down PTO (paragraph 2-27).
2-29.
OPERATE AIR CONDITIONER (ALL EXCEPT M915A2 AND
M916A1).
a.
If cab is hot inside, open windows and allow hot air to vent.
b.
Move mode control lever (2) to VENT and turn fan switch (1) to OFF
position.
C.
Start engine (paragraph 2-14).
NOTE
If outside air is dusty or smoky, mode control lever
should be set to MAX A/C and windows and vent closed
to prevent drawing dust or smoke into cab.
d.
Move mode control lever (2) to A/C. With control at A/C, fresh air is
drawn into cab. With control at MAX A/C, air inside cab is recirculated.
e.
Move temperature control lever (3) to COOL.
2-113
