TM 9-2320-303-10
Table 3-1. Troubleshooting (Con't).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 6. Check transmission fluid level.
If transmission fluid level is low, fill to correct level (Appendix F).
8.
ENGINE CRANKS BUT FAILS TO START.
WARNING
Fuel tank cap may become hot during vehicle operation. Use hand
protection when removing fuel cap.
Step 1. Check fuel gage with ignition switch in ON position.
If empty, add fuel (paragraph 3-6).
Step 2. Check air cleaner restriction indicator.
If indicator is not clear, notify Unit Maintenance.
Step 3. If operating in temperature below 32°F (0°C), check that cold weather
starting procedure was used.
Perform cold weather starting procedure (paragraph 2-12).
9.
ENGINE DOES NOT DEVELOP FULL POWER.
Check air cleaner restriction indicator.
If indicator is not clear, notify Unit Maintenance.
10. ENGINE DOES NOT IDLE PROPERLY.
Step 1. Check air cleaner restriction indicator.
If indicator is not clear, notify Unit Maintenance.
Step 2. If operating in temperature below 32F (0°C), check that cold weather
starting procedure was used.
Perform cold weather starting procedure (paragraph 2-12).
11. ENGINE FAILS TO CRANK WHEN STARTER BUTTON IS PRESSED.
Step 1. Check position of ignition switch.
Place ignition switch in ON position.
Step 2. Check selection of transmission shift selector pushbuttons.
Select transmission shift selector Neutral (N) pushbutton.
3-9
