TM 9-2320-302-34
0109 00-8
WINDSHIELD REPLACEMENT - CONTINUED
0109 00
INSTALLATION - CONTINUED
14.
Wet mounting flange of cab (4) with clear water.
15.
Place windshield glass (1) assembly into windshield opening of cab (4).
16.
With assistant pushing lightly on bottom center of windshield glass (1) assembly, pull one end of lower cord around cor-
ner of windshield glass assembly; go to other side and pull lower cord around other corner of windshield glass assembly.
Have assistant push lightly at top center of windshield assembly. Repeat for top cord.
NOTE
•
If cord binds or starts to tear seal, use safety loop at center and pull back toward point where cord is
bound.
•
If safety loop is not needed, it will pull out when cord is pulled to seat final portion of seal.
17.
With assistant applying light pressure to center of windshield glass (1) assembly, pull both ends of either top or bottom
cord alternately until only a few inches from center (pull both ends at same time). Repeat for other cord.
18.
Finish seating windshield glass (1) and seal (2) by gently pushing all the way around outside edge.
1
2
4
1
2
