TM 9-2320-302-34
0102 00-1
REAR SPRING ASSEMBLY REPLACEMENT
0102 00
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Direct Support
Tools and Special Tools
Tool kit, general mechanic’s (Item 132, WP 0126 00)
Jack, hydraulic (Item 73, WP 0126 00)
Wrench, torque, 15-75 lb-ft (Item 138, WP 0126 00)
Personnel Required
Two
References
TM 9-2320-302-10
TM 9-2320-302-20
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
REMOVAL
1.
Remove four screws (1) and top pad (2) from each of two axle clamps (3).
2.
Remove rear suspension center bearing (WP 0101 00).
3.
With rear of vehicle still raised, remove wheels (TM 9-2320-302-10).
4.
Using a suitable lifting device, remove rear spring assembly (4) from vehicle.
2
1
1
3
4
