TM 9-2320-302-34
0087 00-5
POWER STEERING PUMP REPAIR - CONTINUED
0087 00
ASSEMBLY - CONTINUED
5.
Install end plate (33) on pump body (9) with two seals (30) facing up.
CAUTION
Failure to install locating pin in correct position may cause pump to operate in reverse, which could result in equip-
ment damage.
6.
Install new locating pin (32) in lower left hole of end plate (33).
NOTE
If seals can be seen, port plate must be reversed.
7.
Install new port plate (29) and new cam (28) with arrow on cam pointing up toward locating pin (32).
8.
Install shaft (13) and ten new rollers (27).
9.
If removed, install two new guide pins (26) in rear cover (4).
10.
Install valve (25), spring (24), new packing (23), and valve cap (22).
11.
Install new small packing (21) and new large packing (20) in pump body (9).
12.
Install cover (4) and secure to pump body (9) with five screws (19).
13.
Install new gasket (18) on pump body (9).
14.
Install flange (17), as noted during disassembly, and secure with three screws (16).
16
17
18
9
20
26
21
4
24
2322
25
26
19
