TM 9-2320-302-34
0080 00-20
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0080 00
ASSEMBLY - CONTINUED
30.
Place wood block under head of drive pinion (3) so that inner bearing cone (60) touches inner bearing cup (62). Remove
supports from under differential carrier (1).
CAUTION
To prevent damage to spacer, do not apply pressure after gear touches spacer in front of inner bearing on
drive pinion.
31.
Using press and sleeve that fits inside pinion bore of differential carrier (1), press gear (15) on drive pinion (3) until gear
touches spacer (59). Do not remove wood block.
32.
Install spacer (58) in front of gear (15).
33.
Install outer bearing cone (57).
34.
Using press, apply two tons of pressure to outer bearing cone (57). Move differential carrier (1) in both directions while
installing outer bearing cone.
35.
Relieve pressure and remove differential carrier (1) from press. Install differential carrier on repair stand.
15
1
59
60
SUPPORT
SUPPORT
WOOD BLOCK
WOOD BLOCK
AND END OF
DRIVE PINION
MUST TOUCH
62
3
57
58
15
1
WOOD BLOCK - MUST
TOUCH HEAD OF
DRIVE PINION
ROTATE CARRIER IN
THESE DIRECTIONS
AS CONE IS PRESSED
ON PINION
