TM 9-2320-302-34
0080 00-19
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0080 00
ASSEMBLY - CONTINUED
25.
Install outer bearing cone (57) on top of lead pieces.
26.
Using press, apply two tons of pressure to outer bearing cone (57).
27.
Release pressure and remove wood block.
CAUTION
To prevent damage to equipment, do not press shaft of drive pinion out of gear.
28.
Using press, remove outer bearing cone (57) and lead pieces.
29.
Measure thicknesses of compressed lead pieces. Add measurements of two lead pieces and divide by two to determine
average size of pieces. Add 0.004 in (0.100 mm) to average size. Use this dimension to determine size of spacer
(removed in disassembly, step 45) to be installed between gear (15) and outer bearing cone (57).
15
1
59
3
SUPPORT
SUPPORT
WOOD BLOCK
WOOD BLOCK
AND END OF
DRIVE PINION
MUST TOUCH
57
15
SUPPORT
SUPPORT
WOOD BLOCK - MUST
TOUCH HEAD OF PINION
