TM 9-2320-302-340069 00-3ENGINE INJECTOR AND ECM WIRING HARNESSES REPLACEMENT - CONTINUED0069 00ENGINE INJECTOR WIRING HARNESS INSTALLATION - CONTINUED3.Begin with two longest leads and install terminals (10) over terminal screws (9) on front injector. Tighten screws to 12-17 lb-in (1.25-1.92 Nm).4.Perform procedure in step 3 for remaining injector leads.5.Install harness lead (7) on engine retarder solenoid terminal (8).6.Perform procedure in step 5 for remaining engine retarder solenoid terminals.7.Install harness plate (5) and harness protector (4) on engine injector wiring harness (12) and secure to cylinder head (6)with two screws (3). Tighten screws to 84-132 lb-in (10-15 Nm).NOTEEnsure wires are against cylinder head rail away from possible contact with exhaust valve spring.8.Insert guide clip (11) into oil drain hole at rear of cylinder head (6) to retain injector wires in corner away from exhaustvalve springs.9.Connect two engine injector wiring harness connectors (1) to top and bottom outboard connections on ECM (2). Ensurelocking tangs on connectors are engaged.10.Secure engine injector wiring harness (12) to engine with new tiedown straps as required.11.Install rocker arm cover (WP 0016 00).12.Connect battery cables (TM 9-2320-302-20).7810611512439
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
