TM 9-2320-302-34
0036 00-5
CYLINDER BLOCK ASSEMBLY REPAIR - CONTINUED
0036 00
CLEANING AND INSPECTION - CONTINUED
4.
If any of above measurements are exceeded, replace cylinder block.
NOTE
Perform step 5 before gaging main bearing bores.
5.
Install main bearing caps in original positions. Lubricate cap bolt threads and head contact surfaces with a small amount
of international compound no. 2. Install and tighten main cap bolts to 347-391 lb-ft (470-530 Nm).
NOTE
Replace engine block if not within specification.
6.
Measure each crankshaft main bearing bore (21) in vertical axis with inside micrometer. Dimension should be 5.236-
5.237 in (133.000-133.025 mm). If dimension exceeds limits, replace cylinder block.
20
21
