TM 9-2320-302-34
0036 00-10
CYLINDER BLOCK ASSEMBLY REPAIR - CONTINUED
0036 00
ASSEMBLY - CONTINUED
18.
Using dowel inserter set, install diamond dowel (28) and round dowel (29) in rear face of cylinder block to height of
0.472+/-0.002 in (12.0+/-0.5 mm). Angular orientation of diamond dowel must be perpendicular to centerline (30)
through round and diamond dowels within +/- 4 degrees.
19.
Using dowel inserter set, install diamond dowel (31) in front face of cylinder block to height of 0.472+/-0.002 in
(12.0+/-0.5 mm). Angular orientation of diamond dowel must be perpendicular to centerline (32) through bull gear
pilot bore (33) and diamond dowel within 4 degrees.
20.
Install air compressor oil supply line elbow.
21.
Install air compressor coolant supply elbow.
22.
Perform cylinder block pressure testing (WP 0040 00).
23.
Install six plastic weep hole plugs.
24.
Install crankshaft (WP 0033 00).
25.
Install pistons and cylinder assemblies (WP 0041 00).
26.
Install cylinder head (WP 0018 00).
27.
Install gear housing assembly (WP 0035 00).
28.
Install oil cooler, core, and oil filter adapter (TM 9-2320-302-20).
29.
Install oil fill tube (TM 9-2320-302-20).
30.
Install oil dipstick and tube (TM 9-2320-302-20).
31.
Install fuel pump and lines (TM 9-2320-302-20).
32.
Install fuel filter adapters (TM 9-2320-302-20).
33.
Install electronic control module (TM 9-2320-302-20).
34.
Install engine injector wiring harness (WP 0069 00).
35.
Install oil temperature and oil pressure sending units (TM 9-2320-302-20).
END OF WORK PACKAGE
30
32
33
31
29
28
