TM 9-2320-302-34
0033 00-16
CRANKSHAFT REPLACEMENT - CONTINUED
0033 00
INSTALLATION - CONTINUED
23.
Install hydraulic ram and pump (5) on crankshaft gear inserter/remover base post (2) threaded rod as shown. Install
inserter/remover stop nut (26) on end of inserter/remover base post threaded rod. Tighten stop nut.
CAUTION
Ensure timing gear is indexed with woodruff key. Failure to do so could result in damage to equipment.
NOTE
Ensure timing wheel is firmly seated against crankshaft flange.
24.
Operate hydraulic ram and pump (5) to press crankshaft timing gear (4) on crankshaft until timing gear is firmly seated
against timing wheel (8). Obtain maximum force of 3.37 tons (30 kN) when pressing crankshaft timing gear on crank-
shaft.
25.
Remove crankshaft gear inserter/remover tool.
26.
Measure gearlash between crankshaft timing gear and bull gear assembly. Gearlash must be 0.002-0.009 in (0.051-0.229
mm) for new parts and a maximum of 0.012 in (0.305 mm) for used parts.
27.
Install bull/idler gear (WP 0037 00).
28.
Install flywheel housing (WP 0024 00).
29.
Install pistons and cylinder assemblies (WP 0041 00).
30.
Install oil pump (WP 0029 00).
31.
Install timing reference sensor (TRS) (TM 9-2320-302-20).
32.
Install synchronous reference sensor (SRS) (TM 9-2320-302-20).
END OF WORK PACKAGE
4
5
2
26
8
