TM 9-2320-302-34
0032 00-17
CYLINDER HEAD REPAIR - CONTINUED
0032 00
ASSEMBLY - CONTINUED
NOTE
If injector tube falls off installer during installation, use injector tube reconditioning set tube remover pilot to
retain injector tube on installer. Remove pilot after hold down clamp is installed and tightened.
13.
Install injector tube reconditioning set installer (28) with injector tube in injector bore. Ensure tip of injector tube goes
through small hole in cylinder head (2) fire deck. Tap lightly on end of installer, if necessary, to seat injector tube.
14.
Install injector hold down clamp (37), washer (38), and hold down bolt (39) over injector tube reconditioning set
installer (28). Tighten bolt to 43-49 lb-ft (58-66 Nm).
28
63
64
2
28
38
37
39
