TM 9-2320-302-34
0032 00-16
CYLINDER HEAD REPAIR - CONTINUED
0032 00
ASSEMBLY - CONTINUED
3.
If removed, use cup plug installer to install 11 cup plugs (55) on top, front, and rear sides of cylinder head. Install cup
plugs to 0.098-0.138 in (2.5-3.5 mm) below machined surface.
4.
If removed, install two cup plugs (56) on front and rear sides of cylinder head to 0.098-0.138 in (2.5-3.5 mm) below
machined surface.
5.
Install two square drive pipe plugs (57) on front side of cylinder head, flush-to-below surface.
6.
Install connector (58) on left rear side of cylinder head.
7.
Install elbow (59) on left front side of cylinder head.
8.
Install two pipe plugs (60) on right side rear of cylinder head.
9.
Install pipe plug (61) on right side rear of cylinder head.
10.
Install fuse plug (62) on right side front of cylinder head.
NOTE
Do not lubricate outside of injector tube or inside cylinder head injector tube bore.
11.
Lubricate new injector tube o-ring seal (63) with lubricating oil. Install o-ring seal over new injector tube (64) until flush
against lip.
12.
Install injector tube (64) on injector tube reconditioning set installer (28).
55
56
57
55
58
59
55
55
55
55
60
61
55
62
56
