TM 9-2320-302-34
0029 00-8
OIL PUMP MAINTENANCE - CONTINUED
0029 00
ASSEMBLY - CONTINUED
7.
Place oil pump cover (19), pump body side down, on press support. Apply thin film of lubriplate to bushing bores (25).
8.
Position bushings (24) loosely over bushing bores (25).
9.
Rotate bushings (24) so split lines (A) are aligned in pump cover bushing bores (25) as shown.
NOTE
Bushings must be installed to specified depths below finished surface of oil pump cover.
10.
Press bushings (24) in pump cover bushing bores (25) 0.011-0.031 in (0.28-0.78 mm) below finished surface of oil
pump cover (19).
NOTE
Pump body and pump cover bushings are finished to size after installation in their respective bores. Use sin-
gle point tooling to avoid smearing oil retention surfaces.
25
19
24
25
19
24,25
A
