TM 9-2320-302-34
0029 00-7
OIL PUMP MAINTENANCE - CONTINUED
0029 00
ASSEMBLY
1.
Place oil pump body (20), cover side down, on press support.
2.
Apply a thin film of lubriplate to bushing bores (33).
3.
Position bushings (24) loosely over pump body bushing bores (33).
4.
Rotate bushings (24) so split lines (A and B) are parallel with machined surface (C) of pump body (20).
5.
When properly aligned, split line (A) should measure 0.461in (11.709 mm) to surface (C). Split line (B) should measure
1.726 in (43.84 mm) to surface (C).
NOTE
Bushings must be installed flush to specified depth below finished surface of pump body.
6.
Press bushings (24) in pump body bushing bores (33) not more than 0.031 in (0.78 mm) below finished surface of oil
pump body (20).
24
33
20
24
C
A
B
20
