TM 9-2320-302-34
0026 00-20
CAMSHAFT AND BEARINGS REPLACEMENT - CONTINUED
0026 00
INSTALLATION - CONTINUED
13.
Install three new bolts (12). Tighten bolts alternately to draw thrust plate straight into gear housing assembly. Tighten
bolts to 22-28 lb-ft (30-38 Nm).
CAUTION
Camshaft should be held in place while installing camshaft drive gear bolt to prevent disengaging camshaft
dowel from drive gear hub.
14.
Coat threads and underside head of new camshaft drive gear bolt (11) with international compound no. 2 and install bolt
hand tight.
NOTE
After inserting shoe of retaining plate through access hole of camshaft drive gear, it may be necessary to bar
engine over slightly to align bolt holes in retaining plate with bolt holes in drive gear access cover.
15.
Install retaining plate (6) on gear housing (7) engaging one access hole (8) in camshaft drive gear (9). Install two bolts
(10) in retaining plate and gear housing.
16.
Tighten camshaft drive gear bolt (11) to 55 lb-ft (75 Nm). Then turn bolt clockwise 120 degrees.
17.
Remove two bolts (10) and retaining plate (6).
12
