TM 9-2320-302-34
0016 00-3
ROCKER ARM COVER REPLACEMENT - CONTINUED
0016 00
REMOVAL - CONTINUED
CLEANING
WARNING
Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never exceed 30 psi
(207 kPa). Wear protective clothing (goggles/shield, gloves, etc.) and use caution to avoid injury to person-
nel.
1.
Clean rocker arm cover gasket and ten bolt assemblies with detergent and water. Dry with compressed air.
2.
Clean all old gasket forming compound from rocker arm cover grooves. Clean all dirt and foreign matter from rocker
arm cover.
3.
Remove old gasket forming compound from corners of cylinder head located at front and rear cam cap area.
4.
Clean mesh breather element with detergent and water solution and dry with compressed air.
INSPECTION
1.
Inspect rocker arm cover gasket for cuts, nicks, and breaks. If found, discard gasket.
2.
Inspect all components for wear or damage.
INSTALLATION
1.
Press mesh breather element (11) into breather pocket.
2.
Insert curved end of breather element retaining clip (10) into one breather pocket hole. Press and slide straight end of
clip into opposite breather pocket hole.
10
11
5
