DDEC TROUBLESHOOTING
8.7
SOLDER
Soldering splice connectors is optional. To solder splice connectors:
1. You must use rosin core solder.
2. Check the exposed wire before the splice is crimped in its connector. The exposed wire
must be clean before the splice is crimped.
3. Use a suitable electronic soldering iron to heat the wires. Apply the solder to the heated
wire (not to the soldering iron) allowing sufficient solder flow into the splice joint.
4. Pull on connection to assure crimping and soldering integrity.
All information subject to change without notice.
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
8-25
