8.6
STRAIGHT LEADS
8.6
STRAIGHT LEADS
To splice straight leads:
1. Locate broken wire.
2. Remove insulation as required; be sure exposed wire is clean and not corroded.
3. Slide a sleeve of shrink wrap on the wire long enough to cover the splice and overlap the
wire insulation, about14 in. on both sides.
4. Insert one wire into splice clip (P/N: 0597428 or equivalent) and crimp.
5. Insert the other wire into splice and crimp. See Figure 8-19.
Figure 8-19
Spliced Wire
All information subject to change without notice.
8-24
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
