TM 9-2320-302-20
0175 00-2
FRONT BUMPER REPLACEMENT - CONTINUED
0175 00
REMOVAL - CONTINUED
NOTE
Note bolt size and location to aid in installation.
4.
Remove 12 lock nuts (12), washers (13), bolts (14), washers (15), two tow brackets (11), and front bumper (6) from
vehicle. Discard lock nuts.
5.
Lower bumper (6) to ground and disconnect lifting device.
6.
Remove four spring pins (16), flat washers (17), straight pins (18), and two bumper extensions (7) from front bumper
(6).
INSTALLATION
1.
Install two bumper extensions (7) on front bumper (6) with four straight pins (18), flat washers (17), and spring pins
(16).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
2.
Attach suitable lifting device to front bumper (6) using bumper extensions (7) as attaching points.
3.
Install front bumper (6) on vehicle with two tow brackets (11), 12 washers (15), bolts (14), washers (13), and new lock
nuts (12). Tighten lock nuts to 180-200 lb-ft (244-271 Nm).
4.
Install hook (10) on each tow bracket (11) with bolt (9) and nut (8).
5.
Install bracket (5) on front bumper (6) with two washers (4), screws (3), washers (2), and new lock nuts (1).
11
3
4
5
6
1
2
9
10
8
6
7
12
13
14
15