TM 9-2320-302-20
0165 00-2
FRONT HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT - CONTINUED
0165 00
REMOVAL - CONTINUED
3.
Remove brake drum (4) from hub (5).
NOTE
Place suitable container under hub opening to catch axle oil.
4.
Remove six screws (6), lock washers (7), hub cap (8), and gasket (9) from hub (5). Discard gasket and lock washers.
5.
Bend back tab on lock washer (10).
6.
Remove jamnut (11), lock washer (10), lock ring (12), and adjusting nut (13) from axle spindle (14). Discard lock
washer.
7.
Remove outer wheel bearing (15) from axle spindle (14). Outer bearing race (16) will remain in bore of hub (5).
8.
Remove hub (5) from axle spindle (14).
9.
Remove oil seal (17) and inner wheel bearing (18) from hub (5). Discard oil seal.
NOTE
Perform step 10 if bearing races are damaged or if installing new bearings.
10.
Remove inner bearing race (19) and outer bearing race (16) from bore of hub (5).
NOTE
ABS tone ring must be replaced if ring is damaged or if replacing hub.
11.
To remove ABS tone ring (20) from hub (5), tap lightly beneath ring with a small hammer. Use a circular pattern with
light tapping to prevent ring from cocking.
14
17
18
19
5
16
4
15
13
10
8
22
7
6
9
11
12
20
