7.1
DDEC ECM SOFTWARE FEATURES
7.1.18
Injector Calibration Codes
Injector calibration codes can be set with the DDR or programming station only. Codes are
password protected. Allowed range is 01 - 99.
7.1.19
Input Functions
DDEC has twelve digital input ports listed in Table 7-1, located on the Vehicle Interface Harness.
These digital inputs can be configured for various functions, listed in Table 7-2. These functions
can be ordered at the time of engine order. Any digital input function is able to be customized by
programming the ECM with a the programming station.
Input Cavities
Input Cavities
E1#451
G2#543
F1#542
H2#524
G1#528
J2#531
H1#523
K2#583
J1#541
G3#545
F2#544
K3#979
Table 7-1
Input Cavities
Functions
Functions
Functions
None
Limiting Torque Curve
Trans Retarder Status
Engine Brake Low
Diagnostic Request
Dual Throttle (LSG)
Engine Brake Med
Alt Min VSG/Fast Idle
A/C Fan Status
Aux Shutdown #1
Service Brake Release
Aux CLS
Aux Shutdown #2
Clutch Released
Fan Control Override
Park Brake / ISD
Set Coast OFF DDEC II
VSG Station Change
Idle Validation
Set / Coast ON
VSG Station Complement
Pressure / RPM Mode
Resume/Accel OFF DDEC II
Air Load Switch
Throttle Inhibit
Resume / Accel ON
In Neutral Switch
RPM Sync (Marine)
Cruise Enable
In Gear Switch
RPM Freeze (Marine)
PGS System Enable
KD Brake
Rating Switch #1
SEO / DIAG Request
Gas Valve Diagnostic
Rating Switch #2
Engine Brake Disable
-
Table 7-2
Available Input Functions
7.1.20
Jake Brake (See Engine Brake)
For information on the Jake Brake®, refer to section 7.1.5.
All information subject to change without notice.
7-8
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
