TM 9-2320-302-20
0122 00-3
TRANSMISSION OIL COOLER LINES AND FITTINGS REPLACEMENT - CONTINUED
0122 00
INSTALLATION - CONTINUED
2.
Install two elbow fittings (19 and 20) to transmission oil cooler (23) and tighten jamnuts (21 and 22).
3.
Position transmission oil cooler lines (6 and 7) to vehicle.
4.
Connect transmission oil cooler lines (6 and 7) to two elbow fittings (19 and 20).
WARNINGS
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesives
or sealing compound contacts skin or clothing, wash immediately with soap and water.
5.
Apply pipe sealing compound to threads of elbow (18) and install elbow to elbow (19).
6.
Connect transmission oil sample line (17) to elbow (18).
NOTE
Perform steps 7 through 11 at front of transmission.
7.
Install two new preformed packings (16) to elbow fitting (11) and fitting (12).
8.
Install elbow fitting (11) and fitting (12) to transmission (15) and tighten jamnuts (13 and 14).
9.
Connect transmission oil cooler lines (6 and 7) to fitting (12) and elbow fitting (11).
10.
Apply pipe sealing compound to threads of temperature sensor (10) and install temperature sensor to elbow fitting (11).
11.
Install wire terminal (9) to temperature sensor (10) with nut (8).
NOTE
Perform steps 12 and 13 to attach two transmission oil cooler lines to each of four support brackets.
12.
Position clamp (4) around transmission oil cooler lines (6 and 7).
13.
Install clamp (4) to support bracket (5) with screw (3), two washers (2), and nut (1). Install new tiedown straps as neces-
sary.
14.
Fill transmission oil (WP 0021 00).
END OF WORK PACKAGE
