TM 9-2320-302-20
0090 00-2
UTILITY LIGHT MAINTENANCE - CONTINUED
0090 00
LIGHT REMOVAL
1.
Disconnect utility light wiring connector (6) from cab wiring connector (7).
2.
Remove rubber grommet (8) and pull utility light wiring out from inside cab.
3.
Remove lock nut (9), lock washer (10), and utility light (2) from mounting bracket (11). Discard lock nut and lock
washer.
NOTE
Perform step 4 only if bracket is damaged.
4.
Remove six screws (12), washers (13), lock nuts (14), and mounting bracket (11) from cab. Discard lock nuts.
LIGHT INSTALLATION
NOTE
Perform step 1 only if mounting bracket was removed.
1.
Install mounting bracket (11) on cab with six screws (12), washers (13), and new lock nuts (14).
2.
Install light (2) on mounting bracket (11) with new lock nut (9) and lock washer (10).
3.
Feed utility light connector (6) through cab access and connect to cab wiring harness (7). Install grommet (8).
LAMP INSTALLATION
1.
Connect two wires (5) to lamp (4). Position lamp in utility light assembly (2) and roll rubber seal (3) over lamp.
2.
Install lens retainer (1) on utility light assembly (2).
3.
Install cab liners (WP 0202 00).
4.
Install head liners (WP 0203 00).
END OF WORK PACKAGE
13
7
6
8
2
3
4
1
5
12
9
10
14
13
11
