TM 9-2320-302-20
0084 00-3
BLACKOUT DRIVE, MARKER LIGHT, AND WIRING HARNESS REPLACEMENT - CONTINUED
0084 00
DISASSEMBLY - CONTINUED
ASSEMBLY
1.
Install adapter (25), grommet (24), and washer (23) on enclosure (19).
2.
Install shell (22), connect two wires (21), and install lamp unit (20) on enclosure (19).
3.
Position door (18) on enclosure (19) and tighten three screws (17).
INSTALLATION
NOTE
Quantity of wire tiedown straps may vary. Install new tiedown staps as needed.
4.
Install blackout drive light (15) and ground wire (14) on bracket (16) with new lock washer (13) and nut (12).
5.
Install harness (6) on blackout drive light (15).
6.
Install three screws (11), marker light (10), wire (9), and two new lock nuts (8) on bracket (16).
7.
Insert harness (6) through fender and install blackout light assembly (7), grommet (5), clamp (4), three washers (3), and
new lock nuts (2).
8.
Connect three connectors (1).
END OF WORK PACKAGE
18
21
22
23
24
19
25
6
20
17
