TM 9-2320-302-20
0045 00-3
RADIATOR REPLACEMENT - CONTINUED
0045 00
INSTALLATION
NOTE
Install new tiedown straps, as necessary.
1.
Install air line support (24) on radiator (8) with two washers (23), screws (22), and new lock nuts (21).
2.
Loosely install plate (20) on mounting plate (18) with two washers (19) and screws (12).
3.
Install mounting plate (18) on radiator (8) with four new lock nuts (17).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
4.
Position two isolators (15), washers (16), and radiator (8) on vehicle. Remove lifting device
5.
Install ground cable (14) on radiator (8) with new lock nut (13).
6.
Install two isolators (11), washers (10), and new locknuts (9) on screws (12).
7.
Install fan shroud (7) on radiator (8) with four washers (6) and screws (5).
8.
Install radiator support rod (WP 0044 00).
9.
Install charge air cooler and air recirculation shield (WP 0038 00).
10.
Install condenser (4) in engine compartment with four screws (3), washers (2), and new lock nuts (1).
11.
Install water level probe (WP 0081 00).
12.
Install coolant hoses, pipes and clamps (WP 0042 00).
13.
Install engine hood (WP 0185 00).
END OF WORK PACKAGE