TM 9-2320-273-20
Section II TROUBLESHOOTING
6-5. INTRODUCTION.
Troubleshooting procedures (table 6-1) are limited to those on-vehicle checks for which correc-
tive actions are within the scope of Organizational Maintenance.
Prior to starting any trouble-
shooting, the malfunction should be verified after the transmission has been warmed up to
over 1OO° F (37.8°C) since a cold transmission can give faulty indications. To warm the trans-
mission, run the engine for approximately 10 minutes with the transmission in NEUTRAL.
The transmission will feel warm to the touch.
6-6. TEST EQUIPMENT.
An air pressure gage with a range of 0-150 psi (0-1034 kPa) is required to check for proper
air pressure.
6-2
